Running a Saved Report Setting

1. Go to Reports , then select the name of the saved report setting (from the Reports list on the left pane).

   Note: The saved report setting runs again at the moment that you open it. On All Points and Manual Override reports, the updated Report time displays near the top of the report's window. On Energy Usage and Runtime reports, the updated time is reflected by an updated Start Date and End Date in the table.

   Note: The Updated At date and time (in the expanded details on the left pane) is the last time the report setting was modified (Save was selected). It is not the last time the report was run.

2. Do any of the following to locate and view particular saved points:

   • Filter the displayed points by typing in Search on Point/Device.

   • Increase or decrease the number of Rows per page.

   • Use the previous and next arrows to display points listed on other pages.

   Note: The report runs again only on the points that were selected when the report setting was first saved. These are listed next to Points in the expanded details on the left pane. For saved Manual Override and Out of Range report settings, adjusting the priority level or max and min values will not return points outside of the set listed in the expanded details. To search all points of interest in the project again, create a new report by selecting Add New Report.

   Note: If Search All is next to Points (in the expanded details on the left pane) all points of interest in the project were included when the report setting was initially saved.

3. For All Points, All Points By Device, Manual Override, and Out of Range reports, take any desired Actions on points by selecting Set Value/Clear Override .

   Note: This opens a window where basic and advanced settings can be adjusted for the point. For details, see Using a Report.

4. If you want a historical snapshot of these report results, select Download CSV.