(Optionally) Installing the Wi-Fi Antenna

Do you find this article helpful? Help us improve by sharing feedback: Give Feedback

Note: To mount the antennas remotely, see (Optionally) Installing the Antennas Remotely.

Setting up Wi-Fi Antenna

Wi-Fi is required only for initial setup. If the laptop used for configuration is close enough, the Wi-Fi signal strength should be adequate without mounting the antenna. However, if Wi-Fi will be used (as a wireless access point or client) for operation on the job site, be sure to install the antenna and change the Wi-Fi defaults during the configuration. (See Configuring Wi-Fi Settings).

1. Screw on the included Wi-Fi antenna.

   Note: Use only the supplied or approved replacement antennas.

2. Secure each antenna by tightening the rotating head of the connector until it firmly holds the antenna in the preferred position.

Continue to Mounting the Gateway.

We value your feedback!

Help us improve this article: Click here to take a 3-minute survey. Your input helps us make our articles clearer and more useful.