Configuring an All Points Report

For viewing once

  1. Go to Reports , then select Add New Report.

  2. From the Choose a Report dropdown menu, select All Points.

    Note: A table appears showing the values (at the Value Last Read time) of all licensed points of interest in the project.

    Note: Switch Show Time to On to see a table column showing the Value Last Read time.

    Note: To see any changes to point values after the Value Last Read time, first wait for the duration of the Point Update Wait Interval, then close the new report's window and repeat steps 1 and 2.

    Note: The Point Update Wait Interval is in Settings > Protocols. (See Point Update Wait Interval (Minutes) in Configuring Protocol Settings for details.)

  3. Do any of the following to locate and view particular points:

    • Filter the displayed points by typing in Search on Point/Device.

    • Increase or decrease the number of Rows per page.

    • Use the previous and next arrows to display points listed on other pages.

  4. Take any desired Actions on points by selecting Set Value/Clear Override.

    Note: This opens a window where basic and advanced settings can be adjusted for the point. For details, see Using a Report.

  5. If you want a snapshot of these report results, select Download CSV.

  6. Close the new report's window.

To save to run again later

Note: When you save a report, you save that report setting to be run again when you later reopen the report. To save a snapshot of a report's results, select Download CSV.

  1. Complete the actions described in steps 1 to 5 of For viewing once.

  2. Check the boxes next to any points that you will later want to run the report on again.

    Note: If you don't choose any points, the saved report settings will include all the points of interest in the project.

  3. In the text field at the top of the new report's window, clear New Report and enter a descriptive name.

  4. Select Save.

    Note: The saved report's name, with details expanded below it, appears in the list on the left pane.

  5. Close the saved report's window.

    Note: If you want to create and save multiple reports from this same open window, be sure to select Save New for each subsequent report. If you select Save, the new configuration will overwrite the old one in the Reports list on the left pane.

To display the report on a dashboard, continue to Adding a Report Module and/or Creating a Report Card.