Configuring LAN/Ethernet Settings
For increased security, you can only configure these settings when logged into the gateway locally. See Logging In at the Job Site.
For an overview, watch the video below (until the 1:36 mark). For details, consult the following written information.
Network Interface Port Labeling
The network interface ports are labeled differently depending on the model of KMC Commander gateway:
Dell Edge Gateway 3002 |
Ethernet 1 [eth0] |
Ethernet 2 [eth1] |
Wi-Fi [wlan0] |
Advantech UNO-420 |
LAN B [enp1s0] (PoE In) |
LAN A [enps2s0] |
Wi-Fi [wlp3s0] |
Configuring the LAN/Ethernet Settings
Only one LAN/Ethernet port should have a live Internet connection. The ports should not have the same IP addresses.
-
Go to Settings , Network Interfaces, then LAN B [enp1s0] (PoE In) / Ethernet 1 [eth0], or LAN A [enp2s0] / Ethernet 2 [eth1].
-
Switch Disabled to Enabled (if not already).
-
Enter the information in the boxes below as needed.
-
Choose the Network Area Type (LAN or WAN).
-
If the gateway will primarily access the cloud through a cellular connection and you are configuring this Ethernet port for connection to a local subnet, choose yes for either Isolate IPv4 to Local Subnet or Isolate IPv6 to Local Subnet.
Caution: If your local connection is routed and you select yes, it may disable your ability to connect to the gateway locally.
-
Select Save.